Hacking 3D Printers To Add Full Color Capabilities

Spread the love



Hacking 3D Printers To Add Full Color Capabilities






This very interesting approach to adding capabilities to a cheap 3d printer came into our inbox this week.

Aad Van Der Geest has been experimenting with a dual extruder setup that could bring full color printing to cheap filament based printers. His system utilizes 2 i3 style 3d printers merged into one. One extruder is a modified inkjet printer head.

As each layer is completed on the normal extruder, it then moves over and has a pass under the inkjet head, laying down the colors in CMYK for that layer. As you can see, this prototype is functional, but has a long way to go for the kinds of results people might expect.





Source link

One thought on “Hacking 3D Printers To Add Full Color Capabilities

  • September 17, 2021 at 4:46 am
    Permalink

    hey there and thanks to your information ?I have certainly picked up anything new from proper here. I did alternatively expertise several technical points the use of this site, as I experienced to reload the site many occasions previous to I may just get it to load correctly. I were brooding about if your web hosting is OK? Now not that I am complaining, however slow loading cases occasions will very frequently impact your placement in google and could harm your high-quality rating if advertising and ***********|advertising|advertising|advertising and *********** with Adwords. Well I am including this RSS to my e-mail and can glance out for much extra of your respective fascinating content. Ensure that you replace this again soon..

    Reply

Leave a Reply

Your email address will not be published. Required fields are marked *